Triton 9100 User Manual Bedienungsanleitung PDF herunterladen (Seite 169)

SUPPLEMENT F

SF-3

FULLY SUPPORTS TDM-2XX RETURN CODES

This release fully supports the TDM-2XX return codes. There are two classes of return codes where one

is a soft error that the terminal will accept and retry the failed command. The second class is a fatal error

and will cause the terminal to not retry and go out of service with the error code.

TEST DISPENSE WITH TDM-2XX RETURN CODE INTACT

The TDM-2XX reports a status of the test dispense operation. This release corrects the reporting of that

status information.

TEST FOR TDM-1XXS BEFORE TDM-2XXS

This release corrects the problem of newer TDM firmware that responds to both command sets of the

TDM product line. These command sets changes the way that cassettes are managed and error codes

that are reported. This release will test for a single cassette TDM before testing for a TDM multi-cassette

mechanism.

AUTO RECOVERY FROM 139 PRINTER ERROR (9100 ONLY)

This maintenance release adds the capability to the terminal to auto-recover from an 139 error if possible.

The 139 error condition indicates that the terminal experienced a problem with the printer. Previous

releases required the Terminal Owner to restart the terminal and then reset the error. Now if the printer

recovers from the error, the terminal will constantly test for this state and automatically reset the error and

return into service. If paper was out when this error occurred, within 30 seconds of paper being reloaded,

the terminal will go back in service.

CORRECTING THE SCREEN FLOW FOR THE PRINTER OFF-LINE NOTIFICATION

The Printer off-line notification will now return the customer to the Transaction Cancelled screen then to

the Welcome Screen when the No is selected or the screen exhausts its timeout waiting for input from the

customer.

With this and future versions of 9100 software, when installing an update file over any prior software

release on a terminal with a TDM50, TDM100, or TDM150 dispenser, the cassette multiple amount will

need to be reconfigured before the terminal will go into service**.

**Note - In this situation, if an update file is loaded from Triton Connect, the machine can only be put into

service by configuring the cassette multiple amount in Management Functions at the terminal. Subse-

quent update loads will not require this step.

PIN BLOCK NOT BEING CLEARED BETWEEN EMV TRANSACTIONS

The PIN block is now cleared at that beginning of every Transaction including EMV transactions.

1 2 ... 164 165 166 167 168 169 170 171 172

Keine Kommentare

Triton 9100 User Manual Bedienungsanleitung Seite 169