Triton 9100 User Manual Bedienungsanleitung PDF herunterladen (Seite 75)

GENERAL MAINTENANCE

5. Remove the tab securing the end of the new paper roll to itself. Use scissors to cut off all of the paper

up to and including the glue tab.

Remove the plastic spindle from the old paper roll and insert the spindle into the new roll of paper.

Use a 4-inch roll of 60 mm wide thermal paper.

Be sure the spindle is inserted so that the paper will feed from the top of the roll when it is installed

on the paper bracket.

6. Place the new roll back on the paper bracket by sliding the small, slotted end of the spindle onto the

slot in the bracket as shown in Figure 5-4. Note that the paper feeds from the TOP of the roll!

3. Use the receipt printer feed button (as shown in Figure 5-2) to feed the paper through the paper path

until all paper comes out the front of the printer.

Figure 5-2. Paper feed button location.

4. Remove the paper and spool from the paper bracket (Figure 5-3) .

Figure 5-3. Remove paper roll from bracket.

Figure 5-4. Place paper roll on bracket.

Paper feeds from top of roll!

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 171 172

Keine Kommentare

Triton 9100 User Manual Bedienungsanleitung Seite 75