Triton Isis Bedienungsanleitung PDF herunterladen (Seite 98)

June 2004 Isis® Sonar User's Manual, Volume1

See the procedure entitled

‘To print a single screen from Isis 2.11

or later’

for the related settings.

5.5.3 Using an EPC 9502 Plotter with Isis

Triton Elics has tested an EPC 9502 plotter (serial number 109). It

works with the current version of Isis.

1. Follow the general procedure described in §5.2.

2. From the File→Print→Plotter Setup series of menus in the Isis

software program, choose EPC 980X as your plotter.

Note: Unlike the EPC 1086 plotter model, the EPC 9502 does not

require that you make special settings at the plotter.

Consequently, you can print single-screen images or

continuous waterfall images from Isis without any changes.

5.5.4 Waverley 195 Plotter with Isis

As noted above, the Waverley 195 plotter is the same as the Dowty

195, Ultra 195 and Ultra 200 plotters. Before you can use any of

these plotters with Isis, check to see that your plotter is properly

connected and configured for Isis. You also may need to run some

simple tests if you don’t get any printed output. Use the following

procedures as a guide.

To connect the plotter to your Isis

1. Take a standard printer cable (not a straight-through DB25

cable) and connect one end to your LPT1 port.

2. Connect the other end to the parallel port interface labeled

“Centronics”.

To configure the plotter for Centronics mode of operation

1. Choose Standby mode.

2. Press [Shift] [ONLINE] until SBY appears.

3. Press SETUP twice.

4. Press ENTER until Centronics appears.

Chapter 5: Printing in Isis

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 309 310

Keine Kommentare

Triton Isis Bedienungsanleitung Seite 98